Anderson Manufacturing AM-15 80% AR-15 Lower Receiver - Anodized Black

Manufactured by Anderson Manufacturing
SKU: D2-K067-C000
MPN: D2-K067-C000
Manufactured by Anderson Manufacturing
3 Reviews
$40.00

Out of Stock

Details

Details

Note: 80% Lower Receivers, Frames, and Kits may only be returned in new, unmodified condition.

Build your very own AR-15 lower receiver with the Anderson Manufacturing AM-15 80% lower receiver. This 80% lower is not classified as a firearm and can be shipped directly to your door. Once you drill the holes for the trigger/safety assembly and mill out the rear lug pocket, it can then be assembled into a functioning firearm. It is forged from 7075-T6 aluminum and type III hardcoat anodized black.

Note: It is recommended to use the 80% Jig Kit (G2-T342-0002) to ensure proper placement of the drill bit.

Features:
  • Forged 7075-T6 aluminum
  • Hardcoat anodized black
  • Multicaliber
  • ¾” grip screw

Anderson Manufacturing builds rifles, pistols, and parts utilizing the latest in computerized manufacturing. By keeping manufacturing in house, Anderson can offer quality, American-made products at an affordable price, backed by a limited lifetime warranty.
See More

Specifications

Assembly80 Percent
BrandAnderson Manufacturing
Caliber MarkingMulti-Caliber
FinishHardcoat Anodized
Receiver Material7075-T6 Aluminum

Ratings & Reviews

3 reviews

4
  • 5 stars
  • 0 reviews
  • 3 stars
  • 0 reviews
  • 2 stars
  • 0 reviews
  • 1 star
  • 0 reviews

A solid buy save for one issue, check upper fitment prior to milling.

by

Lower looks fine, anodizing is good, no marks or nicks or whatever. Only issue that arose was that the takedown pin pocket was too small for for the lugs on a total of 5 uppers I tried of various brands. I only found this out after milling/drilling and removing from jig. It's not just one of them either, I've got four total to make and none of them would seat properly. I am using an 80% Arms Easy Jig Gen 2 and would recommend that to everyone because of repeatability. I was able to reinsert lower into the jig and cut out the wall between the two pockets without any issues as far as alignment. Other than that, 100% would recommend. This was also the fourth one so far with jig.

A solid buy save for one issue, check upper fitment prior to milling.

by

Overall no complaints. Only snag I hit was with the rear takedown pin pocket was too small for the lug on a total of 5 different uppers from various manufacturers. Wasn't just a single lower either. I have 4 in total and none fit. Was an easy fix with my 80% Arms Easy Jig Gen2. I just milled out the wall separating the two pockets. Would still recommend to anyone.

Mostly nice

by

Ordered 2, both had perfect finish and good fit with various uppers. One of the 2 had a slightly undersized pivot pin hole which was easily remedied, it's just unfortunate to need to remove some of the finish.