Anderson Manufacturing AR-15 Lower Receiver - No Logo

Used this lower for an AR pistol and the fit is perfect. The finish is awesome. Since there's no logo I'm planning to do my own design with a CNC machine.

I have built rifles and on almost every major lower out there, and recently I purchased two of the Anderson Ghost lowers to build a couple of rifles along with the Anderson .458 SOCOM stripped uppers. Everything went together as one would expect, the fit and finish were excellent, and as far as I am concerned, these parts are the equal to uppers and lowers costing two or three times more. The front of the uppers needed very little lapping to bring them to true square and the lowers accepted all parts without a hitch, and when combined, they not only look good but perform perfectly. I could not be happier and I will be ordering more of the Anderson Ghost lowers. My only three complaints, if you can call them that, are that I wish Anderson would make their lower with the machined in trigger guard in the Ghost configuration, would include full auto bullet markings in addition to the safe/fire pictographs, and third, put the bullet pictographs on both sides.

I used this lower to build an AR47. I had my rate and rank laser engraved in the blank area and then had the upper and lower set cerakoted. The engraving looks like it came from the factory.

I've used two of these so far. No issues with assembly, nice fit and finish and really the least amount of markings you're going to get outside an 80% lower. Will buy more.

Built two pistols with these so far, one with logo though. Seems to be great with no issues 1k rounds later with both of them. I definitely recommend one for every builder!

Ive bought at least 20 Anderson lowers over the years from PA for all my builds. Using open and closed trigger guard lowers there has been ZERO issues ever no matter the upper receiver or other parts used. Why spend more when these run with the best.

This is my second Anderson lower & they haven’t disappointed me yet. Very high quality lowers at a reasonable price, especially in 2020. The holes line up perfect for the takedown & pivot pins as well as the trigger & hammer pins. I had to buy whatever parts I could find available this time but I ended up getting everything I needed & it turned out better than I expected. Sometimes not being able to find parts you would normally buy can help you stumble across some true gems as far as lower parts are concerned. I highly recommend these lowers if you can find them in stock, good luck 😆.

Would have given it 5 star but the last one I put together had a bur, that would’t Let the detente seat on the rear takedown pin. I used a small drill bit to clean the hole up and worked fine after. Fast shipping from Primary Arms.

I read reviews of other lowers and was worried that my Anderson lower would come marred with scratches. It was shipped promptly free of defects. Everything is up to mil-spec and up to par. I would recommend this for builders.

Fit Finish is remarkable! Best part of it all, NO LOGO and Unmarked. Next best thing to a 80% lower