Battle Arms Development Enhanced AR-15 Magazine Release Button - Red
Parallel serrations prevent finger slippage vertically, while reducing drag horizontally as the finger retracts.
Weighing no more than a MIL-SPEC mag release, this button saves on weight it would have gained by a slightly increased height and solid face by skeletonizing the rear.
- CNC machined from billet 7075-T6 aluminum
- Anodized red finish
- Compatible with all MIL-SPEC lower receivers
- Made in the U.S.A.
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
Did not really work
I like the idea and the color but functionality wasn't there. After screwing on as far is to could go because of internal threads and after threading the other side as far as I could go before it started hitting receiver gave it shot. Worked except when you put extra pressure on the button the arm on the other side was pushed too far out and would catch the edge of the receiver and seemed to cant a little. Put the mil spec button back on and not problems. Would probably work but you would have to cut the bolt back on the mag catch and you would think you should not have to do this. Will take space in the drawer until I decide to cut mag catch bolt and try again.
by Richard -
Works and looks great on my AP M5 lower.