Primary Arms 30mm PLx Cantilever Mount - 1.5"
Bucks
Details
Details
As part of the PLx line, these 30mm mounts meet the exacting demands of professional use, offering impeccable craftsmanship and advanced features.
PLx Scope Mounts are 100% US-made from 7075 Aluminum and feature grade 12.9 steel hardware with a proprietary Electroless Nickel coating for unmatched durability in austere conditions. The innovative three-bolt design distributes recoil evenly with over 6,500 lbs of clamping force. Combined with dual machined recoil lugs and 3 cross bolt lugs, PLx mounts can resist heavy impacts and sustained gunfire without ever shifting your zero—all while remaining lightweight and compact. Like all of the products, this mount is backed by Primary Arms' lifetime warranty.
Features:
- 7075 Aluminum construction
- 12.9 Grade steel hardware
- Three bolt design for increased strength
- Dual recoil lugs
- For 30mm scope tubes
- 1.5" Optical centerline
- Primary Arms lifetime warranty
- Rings - 16-18 in. lbs.
- Base - 30-35 in. lbs.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
3 reviews
Solid contender against the Geissele Super mount
by Aaron -
Solid design that is rock solid. Only differences I can think of between this and the Geissele:
-This mount only has 2 recoil lugs, Geissele has 4
-Not sure if this is milled from a single piece of aluminum and the Geissele caps are serialized and directional for perfect fit, but I couldn't find a difference in measurements.
Really good - despite YouTube
by Eric
This is the cheapest 7k series aluminum mount available. 7k aluminum will not bend like 6k. It is really compact and let's the Scar 17 charging handle clear either side. So a bolt action would probably clear this, too.
I saw two YouTube videos complain about this mount not being worth the price and compared it to really cheap 6k series aluminum - apples and oranges. I'm not putting 6k aluminum on a Scar 17 or with a really nice scope.
I'm considering more of these.
Love it, just wish it was a touch higher
by Jordan -
Really sturdy and honestly, good-looking mount, and the only negative is wish it was slightly higher like 1.54”, but not because of head position but because it’s so low that it’s hard to level with the Arisaka optic leveler (the small one”. When you start tightening the scope rings, the Arisaka tool gets stuck and takes some finessing to get out without knocking it out-of-level again. If it was a slight bit higher or even if the flat area under the scope was machined slightly lower, it would be absolutely perfect. But really if you’re using another method to level, that’s a non-issue.