Strike Industries Fang Billet Aluminum Trigger Guard - Red
Details
Details
Strike Industries products are designed by shooting experts for the shooting sportsman.
The Strike Industries Fang Billet Aluminum Trigger Guard is a lightweight, aircraft grade aluminum trigger guard with a bottom ‘fang’ that acts as a guide for faster, more consistent magazine changes.
NOTE: Will not fit Anderson MIL-SPEC lower receivers without modification.
Features:- Aircraft grade aluminum
- (3) M6 hex screws included
- Weight: 0.4 oz
Notice from the manufacturer:
“Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary.”
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
4 reviews
Great product
by Steven -
Fits and looks great!
Out of Spec POS
by Farid
Out of Spec POS. If you need a dremel to shave down your new part it gets a one Star. Front hole near mag well does not line up. Also Front piece of trigger guard to far into magwell. Causes Mag to fit to tight. All other trigger guards fit perfectly on the same Anderson lower.
Great look, bad fit up
by Austin
Buyer beware, this is an awesome trigger guard and once you get it to fit it's great. But from other reviews I've seen, and my own experience, you will likely have to grind out the holes on your receiver slightly to make the trigger guard line up. DO NOT FORCE SCREWS, THEY CROSSTHREAD EASILY. for your reference, the trigger guard is slightly too long for most ar lowers, plan accordingly.
Don't rule it out Anderson owners!
by Pee Dot -
Despite the mil-spec Anderson compatibility warning, I took a chance anyway & the red Fang fit 'my' Anderson mil-spec build just fine... I didn't need to widen any of the holes, as others have stated. It did put up some slight resistance when I initially attempted to secure the two rear screws first, but once I flipped it & installed the front screw first, the rear screws seemed to line right up! No magwell ramp feed/release issues either & I couldn't be more pleased... I'm back now to grab one in FDE & backorder the black my other builds.