Strike Industries Enhanced Ultimate Dust Cover - Capsule - Black
Details
Details
The Strike Industries Enhanced Ultimate Dust Cover is the world's first quick disconnect ejection port cover for the AR-15! Manufactured from high-density Nylon polymer, the UDC will never corrode, rust, fade, or deform. It features an internal True Seal lip to better protect your rifle from the elements. A built-in adjustable detent screw allows you to easily compensate for receiver wear, or increase/decrease opening power.
The spring-loaded internal detent rod provides easy installation and take down, often taking just 5-10 seconds! This enhanced version is thinner, allowing greater compatibility with nearly any AR-15 upper receiver, including billet uppers, on the market as well as reducing the weight to a minimal 0.3 oz! The new design also features a cut-out window for easy installation or removal, all without impacting the True-Seal capabilities!
Features:
- Spring-loaded, internal detent rod
- Polymer construction
- Cut-out window
- Resistant to corrosion, rust and fading
- True Seal internal lip
- Adjustable detent set screw
- Length: 3.46”
- Weight: 0.3 oz
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.Ratings & Reviews
56 reviews
Does not fit.
by Jonathan -
Doesn't really fit in an Aero Precision upper unless you are willing to shave off a few millimeters to have it close which is a bit disappointing.
Buy it.
by Rusty -
Put this on a mil-spec upper receiver to replace a mil-spec dust cover I lost the tiny C/E clip for. The mil-spec dust cover was a pain to get off but it was worth it to get this one on. All you need to do is have some nimble fingers to pull a small spring back and pop the pins into the designated upper receiver holes. Installation was very easy and took seconds. Very durable and no tiny pieces to lose. I will buy this again for my future build(s).
Love this dust cover
by CGS3 -
Put this on a Smith & Wesson M&P 15. A big improvement over the regular Mil Spec dust cover. I plan on putting these on all my AR's. Shipping was fast as usual from Primary.
Nice cover, but…
by Nick
This is a really nice and well made cover, but, it will NOT fit on a Wilson Combat milled upper.
Not so great
by stevet -
looks great, but it barely locks closed. If you just bump the gun it opens. Not sure if there is some thing wrong with just this one or if this is common .
Did not fit multiple mil-spec uppers
by J -
Did not fit. Apparently I'm not the only one experiencing this.