Velocity Systems Quad 5.56 General Purpose Swift-Clip Placard - Ranger Green

Chest rigs are nice, but chest rigs and a plate carrier can be less nice. That's where the  SwiftClip® Placard comes into play.

Designed to be an alternative to a full chest rig. The Placard is lighter and smaller than a standard chest rig while maintaining a variety of storage options.

This Placard in Multicam holds four 5.56 magazines. Each magazine is held in place by an adjustable shock cord retention system. There are also three general-purpose pouches located in front of the magazines.

ID patches can also be attached to the center pouch flap via the loop panel. The whole panel can be quickly added or removed by the two male buckles attached to the SwiftClip® system on plate carriers and vests.

The Placard can also be removed without removing any of the other equipment that might be on the vest. This leaves all of your radio equipment, medical, and other gear in place, so you don't have to set it all up again.

Features:

• Holds four (4) 5.56 magazines
• Three (3) General Purpose pouches
• Two (2) male SwiftClip® buckles
• Loop panel for ID patches
• Adjustable shock cord retention system
• SwiftClip attachment
• Placard: 12" W x 3.5" D x 6.5" H
• Large Pockets: 3.87" W x 1.5" D x 4" H
• Small Pockets: 2.87" W x 1.5" D x 4" H
• Ranger Green
• Made in the U.S.A.

The Quad 5.56 Magazine Placard allows for you to carry a basic amount of ammunition on the front of your plate carrier or vest while still having extra storage.

The ability to quickly remove and replace it allows for multiple setups to be available or swap that setup to another carrier or vest. This allows for consistency across multiple carrying systems.