WMD Guns Nitromet Adjustable Low Profile Clamp On Gas Block - .750"

Manufactured by WMD Guns
4 Reviews


Out of Stock

NOTE: Limit 5 per household. Quantities exceeding 5 will not allow checkout.


Out of Stock


The WMD Guns Nitromet Adjustable Low Profile Gas Blocks offer the same corrosion resistant coating available on their multitude of AR-15 parts. This helps lengthen the lifespan of high pressure components like the AR-15’s gas block. The .750” diameter gas block uses a clamp for its mounting system and is compatible with both dimpled and non-dimpled barrels. The adjustable gas screw allows more control over gas flow in your system giving you the ability to tune your firearm for optimum performance. Made in the U.S.A.

  • .750" internal diameter
  • Adjustable
  • Clamp on style
  • Compatible with Mil-Spec lowers
  • Durable Nitromet coating
  • Installs like a standard component
  • Made in the U.S.A.

WMD Guns has established a reputation of excellence based on extensive firearms and defense industry experience, plating expertise, and gunsmithing capabilities. They are innovators in nickel boron products for the firearms industry and the sole source of the NiB-X nickel boron coating process.


BrandWMD Guns
FinishSalt Bath Nitride
Manufacturer.WMD Guns
Size.750 in

WARNING: This Product can expose you to chemicals which is known to state of California to cause Cancer and Reproductive Harm. For more information, see www.p65warnings.ca.gov

Ratings & Reviews

4 reviews


Works fine if you know what your doing


I ordered two of these, prepared to do some cleaning based on other reviews. There was some crust in them, not a lot. Probably dried cosmoline or something. Then I installed the gas adjustment screw and worked it in and out a few times till it moved freely. Then did the same thing with the gas screw locking screw. It went together just fine, seems heavy duty and clamped onto the barrel well. I see no reason it wont work as intended when I finally get a chance to test and tun the AR pistol and 3 gun setup I built. Is it perfectly ready out of the box like a higher priced gas block, no. But for me, totally worth the 40 dollar cost savings over other manufacturers product.

Works great


Not sure about the other reviews but I have 3 of these, all work perfectly.

Check internal for debris before use

by -

Looks good but had to spend half hour cleaning burrs and some sort of crusty stuff out of the inside, was plugged almost solid inside.

poor manufacturing and quality control. Stay away!

by -

Stay away from this product. I bought two and both were of poor quality. the Gas tube could not even enter the hole at all. I looked down the hole to see if there was an obstruction, and saw and the base there was crude built up. I cleaned, but still could not get the tube in the hole. The second one was only slightly better. It also had crud built up inside the tube. I cleaned it out, but there was either an obstruction or the hole was not deep enough. The tube did not seat far enough to align the roll pin holes. After multiple attempts I gave up. DO NOT BUY THIS PRODUCT!!!!
<br>From PA: I'm sorry that you had this experience. We started a return for you.