Primary Arms Deluxe Extended AR-15 Scope Mount - 30mm
Details
Details
Features:
- For optics with 30mm tube diameters
- Machined from aluminum
- Matte black anodized
- Lifetime Warranty
To make sure that the mount nut is fully tightened, turn the nut clockwise until resistance is encountered. After that, turn another 1/2 turn. If a torque wrench is being used, they recommend no more than 35-40 in-lbs.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
68 reviews
Defective mount, wouldn't clamp onto my rails and scratch up my brand new upper
by ML -
The scope mount is defective. On one of the slots, the metal bolt is uneven and wouldn't clamp on to my receiver. I am very unhappy about this.
From PA: We're very sorry that you received a bad mount. We'll be happy to get a new one out to you or accept a return on that one.
Great Quality for the money!!
by Dan -
Primary arms continues to deliver a great products with a great prices as well!
Works great
by Cam -
It’s worked really well for me, no issues!
Works great
by Brandon -
It’s was the only one in stock at the time and I’m pleased with it saved some money and got a quality product
Excellent Product
by Lawdawg -
excellent product fits the Rails as expected tightens down nicely. the Scope fits Beautifully I get a great Cheek weld on the stock and have no trouble getting a great sight picture through the scope. Large Heavy Scope Does not Slip in the Rings due to Heavy Heavy Recoil!!
Pretty solid for inexpensive mount
by Jay F -
Have had for a month and 2 range trips. Seems pretty good so far. Haven't been able to test to hard yet due to ammo prices. At this time I would buy again.
What you expect for $50
by Jeffemaximo -
These are what you would expect for low cost rings. They got my entry level scope mounted on my lower end AR and work just fine for general range target blasting
If I had a higher end scope on a higher end rifle I would get a better mount solution
Had lap these rings a lot to knock down several high spots and still got around 70% contact area
You get what you pay for. They work for me on my lower end scope. If you’re going to spend a lot on a scope then get better mounts.
Work Great!!
by Andrew J Haussermann -
Used this to mount a 1X6 scope on my Zastava ZPAP M70 AK. You must use an extended mount to get the proper eye relief on an AK along with a cheek rise on the stock. Makes a great set up and clears the rear iron sight.
nice scope mount
by scott -
Easy to put on the rifle snugs up nicely with no wobble. The extension leaves you with good eye relief also. The height of the mount lines up great when cheek is on the rifle butt weld to. I would recommend for the price!
Soft Bolts
by RC -
Scope mount is heavy metal but the bolts are very soft and stripped immediately. I use a fat wrench to 5lbs below the recommended in/lbs and both the bolts stripped and my scope was damaged. Never had this problem before as I don't go past the lowest rated torque. Disappointed. Switched to a different brand and didn't have a single issue.
Note: We are happy that we were able to get you taken care of on this issue. Please let us know if we may assist you with anything else.