Midwest Industries Gen 2 SUB 2000 T1/T2 Optic Mount
Details
Details
The Gen 2 SUB 2000 T1/T2 Optic Mount provides a mounting surface for Aimpoint T1/T2, H1/H2, or compatible clones on the KEL-TEC Gen 2 SUB-2000 Carbine.
NOTE: Not compatible with the Bushnell red dot.
Features:
- Compatible with Aimpoint T1/T2, H1/H2, and clones
- 6061 aircraft grade aluminum
- Hardcoat anodized
- Includes all mounting hardware
- Weight: 2.7 oz
- Made in the U.S.A.
- Lifetime warranty
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.Ratings & Reviews
4 reviews
Wont Hold zero...
by Steve
I bought this mount for my Kel-tec sub2000 gen2. It wont hold zero. There is a slight amount of play in the swivel which allows about 18" shift in the point of impact at 30 yds. I tried to tighten everything down , but still same results.
Will not hold zero
by Dakotah
The mount will not hold zero. There is a little bit of play in the swivel part where it snaps into place.
problem with my midwest mount
by Pierre
I just purchased your sub 2000 and Midwest MI-G2SUB-T2 Kel-Tec Optic Mount but the problem is that although the Midwest solves the mounting issue of a red bot sight well. Their attachment process is lacking, it will not hold zero.The M nuts they provide are not sufficient to hold the sight in place. It may be the plastic hand guard is too soft or more likely the area of the m nuts is small and not sufficient to hold properly. MIdwest has no solution. Does anyone have some kind of a large back plate that covered a larger surface area of the hand guard then the M nuts provide making it more stable/secure? anyone have a solution?.
Mine holds zero
by Mark Wilson
I torqued the rail and torqued all the fasteners properly and it has held zero well. Shot 3 matches with it. Approx. 350-400 rounds. so far.