TTI AR-15 PMAG +5/6 Base Pad - Red
Details
Details
Note: The pin set screws are set with Loctite and is not recommended to adjust them. Remove the metal insert at the bottom before installation.
Features:
- Compatible with AR-15 30 and 40 round PMAGs
- Reverse compatible with Gen2 PMAGs
- +5 in PMAG30
- +6 in PMAG40
- Patented push pin design for easy installation
- No specialty tools required
- Machined from billet aluminum
- Red hardcoat anodized
- Made in the U.S.A.
- Weight: 2.1 oz
- Length: 1”
Taran Tactical Innovations is known for high end customizations and gunsmithing work on some of the most popular guns from Glock to Sig Sauer and even Benelli. If you are looking to improve your firearm for competition use, TTI is one of the best.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
1 review
Tarin Tactical quality and fit is obvious...
by chris -
Great looking extension and has functioned 100 percent thus far. The fit is very tight. I had to use a rubber mallet to get it properly installed on my Gen M3 PMAG. There is no way this thing could every come loose or fall off. The included retaining pin did fall out while I was firing and I never found it. The fit is so tight Idont think it matters that it is gone though. I like it tons but make sure you get banged on and the plate at the bottom of the mag spring seats proprrly or you will not get all the rounds to go in.