AK Master Mount Optic Mount - Full Length Rail

This is a solid rail mount. Doesn’t sit center of the bore, but none actually will unless you get an RS Regulate. Clamps down very tight and has a low profile. If you run an optic that has an ACOG base it’s even lower. I was able to get my Gen 2 cyclops with mini ACOG base to fit on the very rear end of the rail also. I am very satisfied with the set up.

I mounted a Primary Arms SLx 3x32mm Gen III Prism Scope on my WASR-10 with this mount. I've dropped the rifle, knocked it over, kicked it, run into door frames with it, removed it for cleaning a couple of times, and disassembled the WASR enough to replaced the stock and the thing just goes back to zero/holds zero through all of my mistreatment. The closest I have to something negative to say is that it took me about thirty minutes of adjusting and readjusting the tension on it to get a solid lockup that I could remove without tools. Trying to find the sweet spot where there was no wobble when clamped but that I didn't need a screwdriver to pop the release seemed unnaturally complicated. Once I got it, it has held perfectly, and not required any further adjusting, and I've put at least 1,500 rounds downrange with it on and taken it off 3-5 times.

I am doing a semi accurate build on an ak103 to match a spetnaz gun I saw, they used a zenitco side rail and given the cost of this one sale it was close enough for what I wanted to do. It holds my eotech just fine and returns to zero after removal, shots out to 200 yards after removing and installing the optic are on target. Overall I am very happy with the mount and will be buying another.

I bought this mount with the intention of being able to take it off and on. It holds zero. Does not add much weight. I mounted to a Palmetto State GF4 and it fits perfectly. Put a Holosun ACSS reticle red dot with holosun magnifyier.

So I didnt understand the instructions, so I email Ak Masters and they wrote me back in less than 15 minutes at 9:30pm incredible. After support what a great mount and fit! So, the secret is the sping load part you push in then use the provided Allen key and a star shaped spring loaded part will go past the spring loaded plate your pushing on. Just make sure the spring loaded star shaped is lined back up to tighten the mount to rifle. Otherwise call or email support thanks.

Excellent fit. Slides on and off with no problems. Best mount I've ever purchased for an AK. This was for my Kalashnikov-USA.

I absolutely love this mount! It’s not too bulky. It looks good. It’s rock solid and easy to adjust the tension for the clamp. Looks amazing with my Holosun 510C and 3x magnifier! I would buy it again if I had another AK

The AK master mount is perfect for solid stability, easy on and off once you've found the setting screw positions.