Anderson Manufacturing AR-15 Lower Receiver - No Logo

Needed to replace some old 80% lowers with serialized ones, uhhgghh politics.

So was looking for some inexpensive functional lowers, and bought a few of these. You can't beat the price, and a lot of good reviews on them and Anderson as a company.

Built them up with various parts kits, everything fit really well, better than some of the higher end lowers I have used. Mated them with three different brands of uppers, nice solid guns, that all tested and ran well. I assumed I would be doing some filling and fitting at this price point, but no need.

We'll see how they wear, but for a millspec build these are my new go to lowers. I would really recommend trying them out

This is a great workhorse lower, without being a billboard with company logos everywhere. There is enough space on both sides for a roll mark or laser engraving to make it your own style.
All mil spec, and "enhanced" parts I have ever used fit perfectly.
The coloring is somewhere between the ashy military (gray-black) color and the super dark black Aero look. A regular oiling and wipe down darkens the color quite well to match many darker mil spec and billet uppers. The finish holds up well- and for you OCD guys, get some Aluminum Black and you can fix any blemish that will happen in the future (gouges and scratches).
All lowers have worked flawlessly once built.

Outside appearance and fit was flawless.
So far everything is in spec.
The magwell has some rough machining but it has 0 negative effect on it. Mags seat well as they should.
Only downside to this lower is the roaches are buying them up and trying to flip them for $150.

Fit Finish is remarkable! Best part of it all, NO LOGO and Unmarked. Next best thing to a 80% lower

I read reviews of other lowers and was worried that my Anderson lower would come marred with scratches. It was shipped promptly free of defects. Everything is up to mil-spec and up to par. I would recommend this for builders.

Would have given it 5 star but the last one I put together had a bur, that would’t Let the detente seat on the rear takedown pin. I used a small drill bit to clean the hole up and worked fine after. Fast shipping from Primary Arms.

This is my second Anderson lower & they haven’t disappointed me yet. Very high quality lowers at a reasonable price, especially in 2020. The holes line up perfect for the takedown & pivot pins as well as the trigger & hammer pins. I had to buy whatever parts I could find available this time but I ended up getting everything I needed & it turned out better than I expected. Sometimes not being able to find parts you would normally buy can help you stumble across some true gems as far as lower parts are concerned. I highly recommend these lowers if you can find them in stock, good luck 😆.

Ive bought at least 20 Anderson lowers over the years from PA for all my builds. Using open and closed trigger guard lowers there has been ZERO issues ever no matter the upper receiver or other parts used. Why spend more when these run with the best.

Built two pistols with these so far, one with logo though. Seems to be great with no issues 1k rounds later with both of them. I definitely recommend one for every builder!

I've used two of these so far. No issues with assembly, nice fit and finish and really the least amount of markings you're going to get outside an 80% lower. Will buy more.