Battle Arms Development Enhanced AR-308 Pivot and Takedown Pin Set
Details
Details
Features:
- Compatible with DPMS Gen 1 .308 receivers
- Not compatible with Ruger 762
- Improved gripping surface
- Low profile pin heads
- Compatible with ambidextrous safety selectors
- Extended length
- Bullet tip guide
- Includes detents and springs
Battle Arms Development, Inc. is a design, research, and development firm focusing on small arms design including firearm components, tools, gauges, accessories, and complete weapon systems. All B.A.D. Inc. products are made in the U.S.A. and held to the highest manufacturing standards to exceed the expectations of the most demanding users.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
1 review
Very nice but pivot pin a bit too long
by StinkFinGr
I used this on a Grey Ghost Precision large frame receiver set. These pins seem to be very well made. They have a nice shiny finish and snap into place solidly. The pivot pin (front pin) has a head that is easy to grip and pull. My only issue, and a big one for my situation, is that the receiver set fits very tightly, no wiggle or space at all between the pivot pin holes and the rear takedown pin holes. The pivot pin of this set stands approximately 1/32" proud of the pin hole when pulled to the open position. This is enough to block inserting the upper receiver pivot pin ears into the lower, making it impossible to mount the upper. I had to file down the end of the pin to allow mounting but of course this ruins the finish and look of the pin. Some careful filing and a bit of touch up paint and it looks fine, but would rather not have to deal with this. The rear pin fits perfectly. Some snafus to be expected when dealing with LR 308.