Forward Controls Design Delta Point Pro Plate for GLOCK MOS Pistols

OPF-G, DPP (Optics Platform, Forward Controls, Delta Point Pro) is the latest member of the OPF line. OPF-G, DPP uses the same proven design of the OPF-G, RMR to keep the Delta Point Pro immobile, the simplest and most effective way to prevent sight to plate mounting screws from loosening and shearing.

While Leupold's Delta Point Pro uses 4 recoil lugs (twice as that of the RMR's) and beefier mounting screws, the challenges of keeping the sight on the plate without loosening or shearing the sight to plate screws are not very different from those of the RMR. OPF-G, DPP has a front and rear fence, the tight tolerances of the plate to slide, and sight to plate insures minimum movement along the bore in recoil.

Note: Do not use OPF-G, DPP with Holoson SCS320, it will damage the plate. OPF-G, DPP is not compatible with SIG Romeo X Pro (lug holes are too shallow on the X Pro). Vortex Defender comes with 2 sets of M4 screws, a longer pair at 11mm, and a shorter pair at 9.8mm. The 9.8mm screws at times are 9.87mm, and this will cause the screws to protrude under the plate, the plate will bend during installation. Be sure to check your screw lengths before using them.

Features:

• 4140 Steel
• Black Nitride Coated
• Mounts Leupold Delta Point Pro Footprint to GLOCK MOS
• 2 Plate to slide screws (M3 0.5mm x 6mm)
• Plate to slide torque value: 13 in/lb
• Sight to plate torque value: 25 in/lb

Compatible with:

• GLOCK 17, 19, 20, 21, 22, 23, 26, 34, 40, 45, 47, and 49 MOS pistols
• GLOCK 40 10mm uses Set 02 plates that are slightly wider, while OPF-G, DPP still works with it, it will not completely fill the MOS cut's width.
• Vortex Defender ST, XT, and XL
• EOTech EFLX (Reuse sight screws that came with the EFLX. Do not use DPP sight to plate screws)

OPF-G, DPP ships with 2 plate to slide screws (M3 0.5mm x 6mm) and a packet of VC3 Vibra-tite. A torque wrench is necessary to properly install both the plate to slide, and sight to plate screws.