Forward Controls Design Mounting Plate for GLOCK 17/19 MOS - RMR/SRO
Details
Details
Fits:
- Glock Gen 4/5 G17, G19, G34, G35, G41 (width 25mm/1 inch), G40 with Set 2
Features:
- Manufactured by Forward Control Design
- Machined steel
- Compatible with Trijicon RMR and SRO optics
- Weighs .83oz
- Plate to slide torque value: 13 to 15in/lb
- Sight to plate torque value: 13in/lb
The Glock optics plates are shipped with plate to slide screws (M3-0.5mm x 6mm, same as what Glock MOS plates uses) and sight to plate screws (6/32 x 3/8), a T10 key and a VC3 packet.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Ratings & Reviews
5 reviews
Perfect Fit
by Will -
This mounting plate fit my G45 10x better than the MOS plates. I installed this to use with a Holosun 508T and the fit is great. Not loose nor did I need to force it in. Can't recommend this enough.
The Best Glock plate
by M9130 -
This is by far the best Glock MOS plate on the market. The plate fits the slide perfectly hanging over just enough on each side to seal to the bottom of the RMR or SRO. The "fences" in front of and behind the RMR can be tight or require minor fitting but make for a custom fit to your RMR and ensure its not going to have unneeded stress to the mounting hardware. And the look of it is just hands down better than the factory MOS plates, no gaps in front or behind the sight and no sealer plate below the optic. Definitely worth the money spent on a Quality product.
Perfect, solid mount
by Adam -
Purchased this plate in response to the issue with the Glock OEM plates not fitting well and snapping the screws under recoil. This plate fits incredibly tight, so much so that it requires some light taps from a delrin mallet to seat it fully. However, it's clearly a massive upgrade and a necessity from a safety standpoint, instilling confidence that the optic is properly mounted and no doubts on whether or not the next shot will eject the optic from the slide. The quality is superb, the instructions clear and concise, and all future optics will be mounted with the same plate.
Way better than the OEM Glock plate.
by Jack -
As stated in the title this plate is far superior than than the Glock OEM plate. Fit and finish is excellent. It's a very tight fit to get on, but perfect. Highly recommended!
The ONLY M.O.S. plate I use.
by ZenShooting
I'm surprised there are so few reviews...
GM in CO, these plates survive 20k rounds per year on my practice gun. I have several, one with close to 50k rounds in approx. 2 years, multiple weather conditions, with no adjustment or re-tightening required. This is the ONLY M.O.S. plate I now use.
Fit is precise and reduces reciprocating stresses on the mounting screws. Shame on Glock for putting out such a sub-standard mounting plate on duty pistols, but this is the solution. In my opinion, it's a necessity for your M.O.S. pistol.