Magpul CTR MOE 0.75" Cheek Riser - ODG

Getting a proper cheek weld on a non-AR platform fitted with a CTR, MOE, DT, or PR stock should not require a custom stock solution. The Magpul CTR/MOE 0.75" Cheek Riser in OD Green raises the cheek weld height by three-quarters of an inch to accommodate optics and sight configurations that the standard stock comb height cannot support.

The Magpul CTR/MOE 0.75" Cheek Riser is a clip-on polymer cheek pad designed for CTR, MOE, DT, and PR Carbine stocks, raising the shooter's cheek weld height by 0.75 inches to improve optic alignment on non-AR15/M4 platform applications — in OD Green.

The riser clips directly onto the stock comb without tools, adhesive, or permanent modification, allowing it to be installed and removed based on optic configuration changes or platform swaps. The 0.75-inch height increase addresses the gap between standard stock comb height and the eye position required by scope mounts, raised optic bases, and elevated sight systems common on M14, SOCOM, and similar non-AR carbine stock conversions. The OD Green color matches the stock finish on green-configured builds and pairs with Magpul's OD Green stock lineup for a consistent appearance across the complete stock assembly. Note that on AR-15/M4 platforms, this riser will interfere with charging handle function unless the stock is fully extended, making it primarily suited for the non-AR applications it was originally designed for.

• Color: OD Green
• Height Increase: 0.75 inches
• Installation: Clip-on, no tools required
• Compatible Stocks: CTR, MOE, DT, PR Carbine stocks
• Primary Application: Non-AR15/M4 platforms (M14, carbine stock conversions)
• AR-15/M4 Note: Will interfere with charging handle unless stock is fully extended
• Made in the USA

Compatible with CTR, MOE, DT, and PR Carbine stocks. Primarily designed for M14 and non-AR carbine stock conversions. On AR-15/M4 platforms, full stock extension is required to avoid charging handle interference.

Injection-molded polymer construction matches the material standard of the Magpul stock lineup, providing the rigidity needed for a stable cheek weld reference point without adding meaningful weight to the stock assembly.

The correct cheek riser for M14 SOCOM and non-AR carbine stock conversions using Magpul CTR, MOE, DT, or PR stocks where the standard comb height does not align with elevated optic configurations. A low-cost, reversible solution that solves a specific ergonomic problem without modifying the stock.

Magpul backs the CTR/MOE Cheek Riser with their manufacturer warranty, delivering USA-made stock accessories that resolve practical ergonomic issues across non-standard platform configurations.