Nightforce XTRM Unimount 30mm 1.5" 0 MOA - Scope Mount

The Nightforce XTRM Unimount in 30mm with a 1.5-inch height and 0 MOA taper is a one-piece cantilever scope mount machined from 7075-T6 hard anodized aluminum in Nightforce's Idaho factory. The 0 MOA configuration provides a level mounting surface with no built-in elevation bias.

The aluminum body is paired with titanium crossbolts and jaws for weight savings and added security on MIL-STD 1913 Picatinny rails. The one-piece cantilever design allows scopes to be mounted further forward than the receiver alone may permit, ensuring proper eye relief and a comfortable shooting position.

A 0 MOA taper centers the scope's available elevation adjustment range equally above and below zero, preserving maximum downward adjustment capability. This configuration is appropriate for rifles used at moderate distances, for shooting at steep downward angles, or for platforms where a 20 MOA base is already installed and additional taper from the mount is not desired.

The Unimount is compatible with 30mm body tube riflescopes and mounts to any MIL-STD 1913 Picatinny rail. The 1.5-inch height is measured from the top of the rail to the center of the scope tube.

One-piece construction eliminates the alignment variables introduced by two-piece ring sets, providing a more rigid and repeatable mounting platform.

The Unimount suits hunting rifles, general-purpose builds, and any setup where a flat mount or a balanced adjustment range is preferred over a long-range-biased taper.

Nightforce Optics manufactures riflescopes and mounting solutions in Orofino, Idaho. Contact Nightforce for warranty details.