Details
Details
RISE Armament Anti-walk Trigger Pins are designed to stay in place. Standard pins may tend to shift over the course of time. If shifted far enough, the hammer or trigger pin could become unseated causing a weapon malfunction. A set of screws threaded into each end of the RISE Anti-walk Pins prevents lateral movement, locking them in place.
NOTE: Dimensional differences between lower receivers may be present. While not an impediment to function, this set of pins may slightly protrude from the side(s) of the lower receiver. Careful filing of the ends of the pin(s) may be applied to correct this purely aesthetic issue, should it arise.
Features:
- Pin 0.154 diameter
- Stainless steel hammer/trigger pins
- (4) included hex screws
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.Ratings & Reviews
12 reviews
Works
by James
They work. Had to drop a dot of blue loctite because they kept loosening on their own but so far so good with a triggertech duty trigger.
Perfect, cheap
by STEPHEN -
Worked perfectly with my Wilson combat lower
Ineffective and poorly designed
by Dan@MN -
I guess you get what you pay for… these are pretty flimsy, and they don’t lock the pins tightly, allowing them to rotate. Get the KNS…
Works on Geissele triggers
by Joe -
I had a problem with my pins walking out on me. I run the entry level, 2 stage- Geissele trigger. Shot a thousands round and had no issues. I would recommend loctiting it after installation.
A little give
by Joseph
Sturdiness seems good. I used these on a Aero Percision M4E1 Thunder Ranch lower. They wiggle back and forth and seem to long. This is the first gun I've built from the bottom up so I was unsure if it was supposed to be that way. After looking at other guns I realized it wasn't. I pulled them placed it in a standard DD lower and it was perfectly placed. Pulled and tried it in a Aero Standard lower and it seemed to fit as well. The Thunder Ranch edition does not work well with these pins.
Great
by Darren
I’ve used these on 4 of my AR builds and they work great for the price. Just do the job right the first time and use some blue thread lock. The last set I ordered had one side of the pin that wasn’t tapped for a screw. Im guessing that someone at Rise overlooked it, Sh*t happens. But a few minutes on the phone and another set is on its way. Thanks PA!
Good deal
by Ken L -
Installed ok but could have used an install cone for the end. Took some time to get the pins through the trigger and the dis-connector even with a Allen wrench as a guide. I always use blue thread lock on these things and anything that could vibrate loose on an AR. It only makes since to secure the screws with thread lock.
Just want I needed
by Dan -
One of my pins loved to pop out. Bought these and haven’t had a single hitch. Must have
Not a walk about…
by John pritchett
These are top quality…work as designed…
**JUNK**
by William -
Hammer and trigger pin screws nearly fell out after only 140 rounds - that totally defeats the point of this product.