Details
Details
The Strike Industries Ambidextrous ISO Latch is a great addition to any SI Latchless Charging Handle. It’s durable nylon polymer construction will be able to tackle the greater heat, as well as the high-pressure gases from short barreled and suppressed rifles. The ergonomic design offers greater surface area to grasp when charging your AR. Since it’s not constructed from aluminum like most latches, it will have better heat resistance, plus it will prevent wear and damage on your receiver but is still strong enough to handle charge after charge. Make racking easier, save your receiver, and pick up some Strike Industries Ambi ISO Latches .
Features:
Strike Industries products are designed by shooting experts for the shooting sportsman. They have anything from AR-15 parts and accessories to Glock components so you can completely customize your set up no matter what you run. Their complete line of innovative products come in a huge variety of colors and finishes so you can not only customize function but personalize your look. You can’t go wrong with Strike Industries.
Features:
- Ambidextrous
- Optimized for SBR and Suppressed Rifles
- Protects Receiver from Damage
- Extended
- Heat Resistant
- Polymer with Nylon fill
Strike Industries products are designed by shooting experts for the shooting sportsman. They have anything from AR-15 parts and accessories to Glock components so you can completely customize your set up no matter what you run. Their complete line of innovative products come in a huge variety of colors and finishes so you can not only customize function but personalize your look. You can’t go wrong with Strike Industries.
Specifications
AmbidextrousAmbidextrous
BrandStrike Industries
ColorBlack
Latch SizeLarge Latch
MaterialPolymer - Heat Resistant
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.Ratings & Reviews
2 reviews
Still Ambi for Latchless Handle
by AnalogLudite
Even though it's for the latchless charging handle, there is a latch to keep it in place, for suppressed or full auto fire. It's not a hook and pivot, it's just a nub on a tang, held in place by the resilience of the polymer. It has a nice high fence for gas diversion, and the additional grip width is adequate under an optic. The screws are pre-loctited, so just put them in, alternating to keep alignment. If you need to extend both sides of the charging handle, this is cheaper than 2 ISO-tabs, and in my opinion, better.
great addition
by brenton s -
great addition to my latchless charging handle gives you just that extra grip area