Details
Details
Features:
- Includes STS Mount, 7mm riser, and 4 screws
- Non-reflective black hardcoat anodized finish
- Ambidextrous mount flip orientation
- Compatible with 1” Weaver or MIL-SPEC Picatinny rails
- Quick detach lock
- Length: 1.66”
- Height: 1.18”
- Weight: 2.9 oz
When used with HWS models 518, 558, 556, 517, EXPS or 516 HWS (with side button interface) the controls can be easily operated, even with the magnifier in the locked position.
To switch the magnifier to the side, simply push the optic to the right or left, depending on how it is mounted. To close the mount, push the magnifier back into its original position until a hard stop is achieved.
Specifications
California Prop 65 warning
WARNING: This product can expose you to chemicals, which are known to the State of California to cause Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.Ratings & Reviews
6 reviews
One critical design flaw not advertised - not for right hand shooters
by Charles -
The latch is on the left side, which is terrible because magnifiers are supposed to be furthest back on the rail. If you move this latch all the way back it blocks the charging handle. This means you will be forced to either use your right hand on charging handle which is doable but it is not how us Army guys are trained. You can move it 2 or 3 spots forward on the rail to make space for your fingers to wrack the charging handle, which is what I have to do. I have an ar pistol so this doesn’t bother me too much that I have to move the magnifier forward but I can imagine on an ar15 platform this would be very annoying.
Even with an extended charging handle you still bust your fingers if you have to use it. You can flip the qd mount around one to solve the problem but it means that when you’re not using it the magnifier is flipped left, which is into your field of view (blocks your non dominant left eye).
Great mount
by Robbie
Overall a great mount. The only issue is that the screws aren’t long enough to engage a PA magnifier. Looks like PA sets their thread below flush which is too far for the EPTech screws to engage.
Works great with a Primary Arms GL 6x Magnifier!
by Jason -
I don't really have anything negative to say about this QD magnifier mount, other than the usual "wish it cost less" and "don't know about it's reliability yet". It matched without a riser with my 1x microprism perfectly.
Works well for my PA micro 3x magnifier.
by Josh
I'm using it on multiple rifles with lower 1/3 Holosun dots. Seems like it would line up fine for absolute cowitness heights too. My only issue is that my package didn't come with any Skittles. I was promised Skittles...
Works well
by Mike -
Easy on and off and does the job. I would buy it again.
Works with Vortex VMX-3T.
by John -
I prefer the Vortex magnifier with my EOTech; the Vortex had better eye relief than the EOTech G33, however, the stock Vortex VMX-3T mount is a little large and is frustrating to use when in "flip-to-the-right" configuration. This mount solves that by taking up less space on the rail and in general, allowing me to properly mount my EOTech 518, VMX-3T, and a BUIS, in addition to being much more user-friendly to flip to the side. It takes a good bit of effort to flip but it is absolutely solid. It comes with risers for the magnifier but I would recommend using the one that came with the Vortex magnifier.
Primary Arms shipped amazingly fast for these times (COVID-19). Great customer service.