Expo Arms MIL-SPEC Standard Carbine End Plate

Great price. Fit Anderson mil-spec buffer just fine, fit Anderson lower just fine.

Finish was perfectly fine on the one I received.

I guess for $2-3 i shouldn’t have expected much. That being said this has the worst finish I’ve seen on a firearm part, I’m not even sure it has a finish. If i weren’t planning on having my firearm cerakoted I’d be sending this back.

From PA: We are sorry you are not satisfied with the endplate. One of our customer service reps will be contacting you.

Used this on my pistol build worked great on the sba brace no issues will buy again.

Well was hoping these would be good. They're under sized. Wont fit on my extension tube.

From PA: We're sorry that you received a bad one and we'd be happy to swap it out for you.

I’ve now used two of these and never had a problem. One on a LWRC and the other in a build. No problems.

The end plate would not fit on the receiver extension but for maybe a quarter-inch. The finish was terrible and running my finger on the inner ring surface detected obvious burrs and imperfections. I had to Dremel the burrs/imperfections to finally get the end plate to fit. Very disappointed in Expo Arms quality control.

From PA: We're very sorry you received a bad end plate. One of our CS Reps will reach out to you.

Not impressed with this item. It looks like it wasn’t finish with the finishing process.

item looks nice but was slightly bent and had to be flattened out. also did not slip on to the buffer tube without using a bit of force. this and the castle nut from this brand were replacements for a BCM mil-spec carbine tube.

This end plate did not fit my Magpul adjustable carbine buffer tube. The plate begins to go over the threads, and then stops inexplicably. Not satisfied.

Very nice back plate, heavy duty with a great finish..... gets the job done! Fast shipping as expected from PA