Ghost Firearms No Logo M-LOK AR-15 Handguard - Black - 10"

It's bent. The rail curls up like a banana. The finish is chalky and doesn't match the receiver. The barrel nut requires a crowfoot wrench to install. The hand guard is not timed. Just tighten it down and hope it doesn't slip. Other than all of that it is not terrible.

Picked up on-sale and I suppose its worth that much for a "very" budget build. Main problems are that the handguard is cast aluminum and did not even have all the casting marks machined out before anodizing. If even a few 1/1000th had been milled off each end it would have cleaned up the overall presentation.

The spec on the rail is a little iffy as well. I have a Magpul MBUS that fits but not quite as snugly as it does on a BCM rail I own. The rail also doesn't quite perfectly match up with the rail on the upper receiver either. Its close but noticeably off.

Great fit and good quality. All the way to North Carolina in just three days. My business will be going to you from now on.

Very easy installation with basic hand tools, works as intended! Perfect length in my opinion

I only knocked off a star because I'd like it to have more than 2 set screws. I feel like I'd be more confident in the product if it had 4 or even 6 set screws like some other brands.

But for the price it's awesome.

The picture doesn't show it. But the barrel nut is checkered like a fine file and the handguard slips over with a little resistance. Then two screws go into the holes you see and clamps down that end of the handguard. On my Anderson upper the top of the rail sits about 2 sheets of printer paper below flush. The recessed top picatinny slots are a little higher than the slots on the upper. The angle side cut for the transition from upper to rail is also off about the same. And as the other reviewer said the finish is chalky. For $30 on sale, I think it's an ok value for a budget build and I would pick up more if it went on sale again. Wink wink. But at full price I would skip it there are way better options and quality for not much more.

Have it on the upper but haven't completed the build. Looks and fits perfectly and easy to install. Very happy with it and thanks for your great service.

Came without the required hardware, no barrel nut or screws, decided to keep it anyways cause it cost more to send it back,

We are happy to be able to get this issue taken care of per our conversation. Please let us know if we may help you with anything else.

It’s alright. It works, it fits really tight to the barrel nut. No special alignment needed to the barrel nut since it doesn’t screw into it. Just like handguard that have tabs to keep them aligned with upper receiver.

I did not receive a barrel nut/screws with my hand guard. Beware, buyers. Seems like a great hand guard but haven't fit it on anything yet.

Happy to hear you received those parts and please let us know if there is anything else we may help you with.

Works great