F-1 Firearms FDR-15 Forged Receiver Set - Black

Manufactured by F-1 Firearms
Manufactured by F-1 Firearms
3 Reviews

Out of Stock

NOTE: Limit 3 per household. Quantities exceeding 3 will not allow checkout.

Items that are regulated by the ATF have restrictions and requirements: 
•Your entire order will ship only to a Federal Firearm License holder.
•Current processing time is approximately 14 to 16 days.
•Please contact your local FFL prior to placing your order to ensure they are still accepting transfers. Due to Covid-19 many are no longer open
•A copy of your order/invoice as well as the current FFL license for your local dealer must be emailed to ffl@primaryarms.com.



The Forged Matched Receiver Set by F-1 Firearms carries above MIL-SPEC tolerances and some distinctive F-1 Firearms lines and features. The receiver set is "All American Made" and offers the standard forward assist and dust cover. Receivers are matched through the finishing process.

  • FDR-15 matched receiver set (billet like features)
  • Manufactured from high grade 7075-T6 forged aluminum
  • Front and rear take down pins included and installed
  • Screws included for bolt catch, receiver tensioning, take-down pin detent and trigger adjustment
  • Groove in top Picatinny
  • Black - Type III Class 2 hard anodizing
  • F-1 Firearms 100% Product Guarantee
See More


BrandF-1 Firearms
Caliber MarkingMulti-Caliber
FinishHardcoat Anodized
Receiver Material7075-T6 Aluminum
Trigger Pin DiameterMIL-SPEC .154
Weight15.4 Oz
Forward Assist
Port Door

Ratings & Reviews

3 reviews


F-1 is super


Truly the finest set on the market. Easy to install the parts and a real clean look


by -

I have to say I was disappointed with the FDR15 set. The forging marks where not cleaned up. The front take down pin was jammed. The upper tension screw stripped when I attempted to adjust it, the anodizing on the threads caused the set screw to seize. The bolt catch was drilled too far away to contact the mag follower properly. My Strike Ind. bolt catch would not engage the mag follower and the mil-spec. catch engaged but not reliably using milspec. and Pmags. The mag well flair was ground off to one side. I had to send the set back to Tim at F-1 for the seized tension screw, the seized front T.D. pin and the bolt catch Issue. I have used many other much cheaper receiver sets that had a better fit and finish. The set was repaired not replaced, bolt catch still doesn't contact the follower to my liking but functions, I am concerned with time the small contact patch will eat into the follower. Customer service was good however I would rather have gotten my money back or compensated.

Might have chosen another set

by -

Was looking for a set for my next build. I ended up ordering 2 different sets. The come in hard plastic cases for each one, Then in examining them they had some slight scratches/wear where they installed the takedown pins. Not sure who put them together if it was F! or Primary Arms. Which I don't really mind. They will end up getting a lot of abuse. What I was not a fan of the take down pins they installed. On both sets I was unable to take the pins out by hand. Had to use a punch and a hammer to get them lose. A lot more force to get them lose then I expected. I guess the positive part is the fitment is tight.
<br>From PA: We don't assemble anything here.