Strike Industries AR-15 Anti-Walk Trigger Hammer Pins

These are the best anti-walk pins on the market as far as I've seen. All of the others require a screw/ bolt in design which can still walk its way out, unless you use a thread locker of some sort. I use these on both my .308 and AR-15.

I got this set to try out with my 6.5 Grendel build with a New Frontier C4 billet lower and they were just a shy bit short and I could not get the last pin to twist and latch together. If you get this product I hope you have a very small socket set. you will need them to lock the pin into the retainer clip.
Over all, I do believe this would be one of the best styles on the market.

These are a novelty item at best. Save your money and buy regular pins. The retainer clip is cheap and broke at the opening after trying to install. Without that clip they are over priced pins. They are not worth your aggravation.

Anti-walk pins that rely on screws are somewhat borderline from an engineering perspective. They are more impact-sensitive than standard T/H pins because the screws are so small / fragile. These pins are solid, so as long as the material is good steel, I expect them to be as impact-tolerant as stock pins.

Easy install. Using with a Blackout Defense Zero Drop in Trigger. Used the tension screws on to the pins and its super TIGHT.

I don't know what else you could ask for. These are easy to install, have no screws, require no torx wrenches, need no thread locker, cost less, are lower profile, and work just as well as other fancier, more expensive competing products. I just wish I had found these before spending 2x+ on the other products. I'm not knocking the other products, they look "cooler" (this is subjective or course), they are available in your favorite color (like peanut butter). If you want anti-walk/anti-rotation pins for your build that work, are simple, easy to install, and allow your to put more money into other upgrades, these are your huckleberry. These (along with SI's ambi mag release) are standard on all of my builds going forward.

These pins sell out so fast, within hours of coming back in stock. These are really high quality pins with very nice and smooth nitride coating. What I really like about these pins is the grooves that the trigger and hammer springs sit in, just like a standard milspec pin. If the side plate were ever to come off, the springs would still hold the pins in, just like standard pins. Perfect design, unlike the smooth pins with no grooves.

This anti-walk trigger pin set is not easy to install the first time but a little use of tiny pliers, and blue tape to protect the receiver finish, will help get that snap plate into place.

Once it's all plugged and in place, this is one sturdy fastening for your trigger assembly.

Pos don’t waste your money. The clip breaks when you try to lock it in

The pins work just fine, the clip to lock them in place is garbage. Spend a few more bucks and get a better setup.