Timney Triggers AR-15 Competition Skeletonized 4lb Single Stage Trigger
Details
Details
Features:
- Single-stage 4 lb trigger pull
- Fits Mil-Spec AR-15 lower receivers with .154” pins
- Drop-in design
- Wire-EDM machined hammer from S7 tool steel
- Lightweight aluminum housing
- Heat treated to Rc 56-60 hardness
- Curved and skeletonized trigger shoe
- Lightened hammer
- Made in the USA.
The Timney AR-15 competition trigger is wire EDM machined from heat treated S7 tool steel with an aluminum housing, so you don’t have to worry about it breaking after years of heavy use. The single-piece drop-in design is easy to install and is more reliable than standard fire control groups because it keeps dirt and debris from getting inside the mechanism. Each and every trigger is individually tested and calibrated by hand before leaving the factory floor.
This AR-15 single stage trigger group is non-adjustable to reduce the amount of parts that are potential failure points, so you can rely on it in any situation. All engagement surfaces are precision ground to produce a smooth consistent pull that breaks in the same spot every time leading to greater accuracy. Not only is this trigger a good choice for competition, but it is great for general target shooting and trying to get the smallest groups.
Timney Triggers was founded in 1946 with the mission to bring consumers high quality, precision AR-15 and AR-10 components. They have since built a reputation that resembles this sentiment by providing triggers that are optimized for competition use by competition shooters. If you have an AR, it needs a Timney trigger.
Specifications
Ratings & Reviews
1 review
Great 4lb Drop In Skeltonized Trigger
by N. Cunningham
I purchased this timney trigger when building my latest Aero M4E1/Midwest Ind/Radian/Magpul build. Personally I like my Ar15 trigger to have a little resistance and I typically like to stay around 4lbs. The build of this trigger group is well machined and built. I tested the trigger pull multiple times with my digital trigger pull gauge and I think the avg is around 3.75lbs. Crisp break and theres almost no re-set. I bought this on sale for $179 and really only go it because of the price and because the skeltonized trigger goes good with my other skeltonized parts like extended mag & bolt releases. The only issue I had and this may be the fault of my Aero lower but this trigger group because of how it and the lower are shaped almost didn't fit. The back hole was slightly off because it couldn't slide fully forward and it made installing the back trigger pin tight. I ended up taping the pin in with my ballpeen hammer but any tougher a install and I probably would've sent it back.